First, check whether the components of the cutting machine are loose and whether there is air leakage in the pneumatic components.

Clean the wire feeding seat and keep the light source seat of the wire taking part clean to avoid dust and inaccurate counting.

Check whether the conveyor belt is loose and clean, so as to avoid dust and dirt contaminating the wire.

In the length setting table, set the length of the required cutting line (unit: mm), if you need to set the inches, please make another table to convert.

Check whether the air pressure gauge is normal, and adjust the pressure gauge to 4KG after checking.

Check the cutter, note that the cutter edge must be facing up before turning on the machine.

The safety acrylic plate is covered before it can be turned on.